Char-Broil 463741209 - Manual (Page 12)

12
Burner Flame Check
• Light burner, rotate knobs from HIGH to LOW. You should see
a smaller flame in LOW position than seen on HIGH. Always
check flame prior to each use. If only low flame is seen refer to
"Sudden drop or low flame" in the Troubleshooting Section.
HI
LO
Hose Check
• Before each use, check to see if hoses are cut, worn or kinked.
Replace damaged hoses before using grill. Use only
valve/hose/regulator specified in the Parts List.
Normal
Hose Kinked
Hose
Turning Grill Off
• Turn all knobs to
OFF position. Turn LP tank off by turning
OPD hand wheel clockwise to a full stop.
Ignitor Check
• Turn gas off at LP tank. Press and hold ignitor button. "Click"
should be heard and spark seen each time between collector
box or burner and electrodes. See "Troubleshooting" if no click
or spark.
Valve Check
• Important: Make sure gas is off at LP tank before checking
valves. Knobs lock in OFF position. To check valves, first
push in knobs and release, knobs should spring back. If knobs
do not spring back, replace valve assembly before using grill.
Turn knobs to
LO position then turn back to OFF position.
Valves should turn smoothly.
CAUTION
If ignition does NOT occur in 5 seconds, turn the
burner controls OFF, wait 5 minutes and repeat the
lighting procedure. If the burner does not ignite with
the valve open, gas will continue to flow out of the
burner and could accidently ignite with risk of injury.
Turn controls and gas source or tank OFF when not
in use.
WARNING
Match-Lighting
s Do not lean over grill while lighting.
1. Turn all burner control valves. Open lid during
lighting. Turn on gas at LP cylinder.
2.
3.
4. To ignite right burner, turn right knob to PRE-HEAT.
Place lit match into match holder, then into side of grill bottom
(as shown below).
Push in and turn IGNITION BURNER knob to PRE-HEAT.
Be sure burner lights and stays lit.
After Lighting: Turn knobs to HI for warm-up.