Dell Latitude E5500 - Manual (Page 53)

Back to Contents Page
Speaker Assembly
Dell™ Latitude™ E5400 and E5500 Service Manual
Removing the E5400 Speaker Assembly
Replacing the E5400 Speaker Assembly
Removing the E5500 Speaker Assembly
Replacing the E5500 Speaker Assembly
Removing the E5400 Speaker Assembly
1. Follow the instructions in Before Working on Your Computer .
2. Remove the bottom of the base assembly (see Removing the E5400 Bottom of the Base Assembly ).
3. Remove the hard drive (see Removing the Hard Drive ).
4. Remove the WLAN card (see Removing a WLAN Card ).
5. Remove the fan (see Removing the Fan ).
6. Replace the processor heat sink (see Replacing the Processor Heat Sink ).
7. Remove the hinge cover (see Removing the Hinge Cover ).
8. Remove the keyboard (see Removing the Keyboard ).
9. Remove the display assembly (see Removing the E5400 Display Assembly ).
10. Remove the optical drive (see Removing the Optical Drive ).
11. Remove the palm rest (see Removing the E5400 Palm Rest ).
12. Remove the two M2 x 3-mm screws that secure the touch pad cover and remove it.
13. Carefully remove the cable assembly from the cable guides.
14. Remove the four M2 x 3-mm screws that secure each of the right and left speaker assemblies to the base of the computer.
15. Remove the speaker assembly.
CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance.
1 left speaker assembly 2 M2 x 3-mm screws (4)
3 M2 x 3-mm screws (2) 4 right speaker assembly