Display, E5400 display assembly, Removing the e5400 display assembly – Dell Latitude E5500 User Manual
Page 14
Back to Contents Page
Display
Dell™ Latitude™ E5400 and E5500 Service Manual
E5400 Display Assembly
Removing the E5400 Display Assembly
1.
Follow the instructions in
Before Working on Your Computer
.
2.
Remove the bottom of the base assembly (see
Removing the E5400 Bottom of the Base Assembly
).
3.
Remove the hinge cover (see
Removing the Hinge Cover
).
4.
Remove the keyboard (see
Removing the Keyboard
).
5.
Remove the display cable from the system board by pulling on the blue tab next to the display cable connector.
6.
Carefully remove the display cable by moving it away from the metal and plastic cable guide tabs.
7.
Turn the computer over. Disconnect the antenna cables from their cards and remove them by moving them out of the cable guides on the bottom of the
computer.
8.
Slide the antenna cables through the hole in the palm rest.
9.
Remove the antenna cables from the cable guides on the top of the computer.
10.
Remove the four M2.5 x 5-mm screws (two per hinge) on the top of the computer that secure the metal hinges.
CAUTION:
Before you begin the following procedure, follow the safety instructions that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance.
NOTICE:
Ensure that the display cable and the antenna cables do not get caught beneath the guide tabs on the palm rest.
1 display cable 2 antenna cables