Dell Latitude E5500 - Manual (Page 26)

8. Lift the display inverter out of the top cover.
Replacing the E5500 Display Inverter
1. Connect the two display inverter connectors to the display inverter.
2. Replace the M2.5 x 5-mm screw that secures the display inverter.
3. Replace the display bezel (see Replacing the E5500 Display Bezel ).
4. Replace the display assembly (see Replacing the E5500 Display Assembly ).
5. Replace the keyboard (see Replacing the Keyboard ).
6. Replace the hinge cover (see Replacing the Hinge Cover ).
7. Close the display and turn the computer over.
8. Replace the bottom of the base assembly (see Replacing the E5500 Bottom of the Base Assembly ).
9. Follow the procedures in After Working on Your Computer .
E5500 Display Panel
Removing the E5500 Display Panel
1. Follow the instructions in Before Working on Your Computer .
2. Remove the hinge cover (see Removing the Hinge Cover ).
3. Remove the keyboard (see Removing the Keyboard ).
4. Remove the display assembly (see Removing the E5500 Display Assembly ).
5. Remove the display bezel (see Removing the E5500 Display Bezel ).
1 E5500 top cover 2 display connector
3 M2.5 x 5-mm screw 4 display inverter connector
5 display inverter
NOTICE: Removal of the bezel from the top cover requires extreme care to avoid damage to the bezel.
CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance.
NOTE: This procedure assumes that you have completed the removal procedure first.
CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance.