E5500 display inverter, Replacing the e5500 display hinges, Removing the e5500 display inverter – Dell Latitude E5500 User Manual
Page 25

Replacing the E5500 Display Hinges
1.
Replace the four M2.5 x 8-mm screws (two per side) and the two M2 x 3-mm screws (one per side) that secure the display hinges to the display cover.
2.
Replace the display bezel (see
Replacing the E5500 Display Bezel
).
3.
Replace the display assembly (see
Replacing the E5500 Display Assembly
4.
Replace the keyboard (see
Replacing the Keyboard
).
5.
Replace the hinge cover (see
Replacing the Hinge Cover
).
6.
Close the display and turn the computer over.
7.
Replace the bottom of the base assembly (see
Replacing the E5500 Bottom of the Base Assembly
).
8.
Follow the procedures in
After Working on Your Computer
.
E5500 Display Inverter
Removing the E5500 Display Inverter
1.
Follow the instructions in
Before Working on Your Computer
.
2.
Remove the hinge cover (see
Removing the Hinge Cover
).
3.
Remove the keyboard (see
Removing the Keyboard
).
4.
Remove the display assembly (see
Removing the E5500 Display Assembly
).
5.
Removing the E5500 Display Bezel
6.
Remove the M2.5 x 5-mm screw from the display inverter.
7.
Disconnect the two display inverter connectors.
1 M2.5 x 8-mm screws (4) 2 M2 x 3-mm screws (2)
3 hinge
CAUTION:
Before you begin the following procedure, follow the safety instructions that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance.
NOTE:
This procedure assumes that you have completed the removal procedure first.
NOTE:
The display hinge panels are labeled L (left) and R (right).
CAUTION:
Before you begin the following procedure, follow the safety instructions that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance.