Dell PowerEdge T105 - Manual (Page 90)

90
Installing System Components
Figure 3-26. Removing and Installing the System Battery
Installing the System Battery
1 Install the new battery with the "+" facing up, and press down until it
snaps into place. See Figure 3-26.
2 Close the system. See "Closing the System" on page 47.
3 Reconnect the system to the electrical outlet and turn on the system and
attached peripherals.
4 Enter the System Setup program to confirm that the battery operates
properly. See "Using the System Setup Program" on page 31.
5 From the main screen, select System Time to enter the correct time and
date.
6 Re-enter any system configuration information that is no longer displayed
on the System Setup screens, and then exit the System Setup program.
7 To test the newly installed battery, see "Troubleshooting the System
Battery" on page 111.
8 After an hour, reconnect the system to a power source and turn it on.
9 Enter the System Setup program. If the time and date are still incorrect,
see "Getting Help" on page 137.
1 battery socket 2 system battery
3 tab
2
3 1
book.book Page 90 Wednesday, April 15, 2009 8:47 PM