Dell OptiPlex Gxi - Manual (Page 107)

1. Disconnect the DC power cable and the interface cable from the back of each hard-disk drive installed in the hard-disk drive bracket.
2. Remove the screw that secures the hard-disk drive bracket to the front of the chassis.
3. Grasp the handle on the front of the bracket, and rotate the front of the bracket up until its tab disengages from the chassis.
4. Lift the hard-disk drive bracket out of the computer.
When you reinstall the hard-disk drive bracket, place the lower-back tab of the bracket into position; make sure that the opening in the lower-back tab fits over the
alignment tab on the chassis. Then rotate the front of the bracket down into position.
Hard-Disk Drive Removal
1. Remove the hard-disk drive bracket.
2. Remove the four screws that attach the hard-disk drive to the hard-disk drive bracket.
One hard-disk drive attaches to the hard-disk drive bracket at the sides of the drive. The other hard-disk drive attaches to the hard-disk drive bracket at the bottom of the hard-disk
drive.
3. Slide the drive out of the hard-disk drive bracket.