Dell Inspiron 2500 - Manual (Page 38)

1. Follow the instructions in " Preparing to Work Inside the Computer ."
2. Remove one or both of the plastic connector covers (one or both of the covers may be installed) by slipping a nonmarring tool into the cutout at the top
and pivoting the tool up to disengage the inner securing tab.
To replace a connector cover, orient the cover notch-side-up and snap it into the connector cutout.
Removing the RJ-11/RJ-45 Board
1. Follow the instructions in " Preparing to Work Inside the Computer ."
2. Remove the system board .
3. Remove the 4-mm screw from the RJ-11/RJ-45 board.
4. Reach into the enclosure and, while pulling the tall plastic tab away from the board assembly to release it, lift out the assembly.
When replacing the RJ-11/RJ-45 board assembly, protect the wiring harness by routing it between the plastic posts as shown in the following figure.
Back to Contents Page
NOTICE: The plastic tab is fragile; pull it back only far enough to remove the board assembly.