beautypg.com

Password status, Boot sequence, Setup password – Dell OptiPlex Gxi User Manual

Page 37: Auto power on, Power management, Password status -7, Boot sequence -7, Setup password -7, Auto power on -7, Power management -7

background image

Using the System Setup Program

2-7

system password and using or changing an existing sys-
tem password. See “Disabling a Forgotten Password”
found later in this chapter for instructions on disabling a
forgotten system password.

Password Status

When

SETUP PASSWORD

is set to

ENABLED

,

PASSWORD

STATUS

allows you to prevent the system password from

being changed or disabled at system start-up.

To lock the system password, you must first assign a
setup password and then change the

PASSWORD STATUS

category to

LOCKED

. In this state, the system password

cannot be changed through the

SYSTEM PASSWORD

cate-

gory and cannot be disabled at system start-up by
pressing <

CTRL

><

ENTER

>.

To unlock the system password, you must enter the setup
password and then change the

PASSWORD STATUS

cate-

gory to

UNLOCKED

. In this state, the system password

can be disabled at system start-up by pressing
<

CTRL

><

ENTER

> and then changed through the

SYSTEM

PASSWORD

category.

Boot Sequence

BOOT SEQUENCE

can be set to

DISKETTE FIRST

(the

default option) or

HARD DISK ONLY

.

The term boot refers to the system’s start-up pro-
cedure. When turned on, the system “bootstraps”
itself into an operational state by loading into memory
a small program, which in turn loads the necessary
operating system.

BOOT SEQUENCE

tells the system

where to look for the files that it needs to load.

Selecting

DISKETTE FIRST

causes the system to try

booting from drive A first. If it finds a diskette that is
not bootable in the drive or finds a problem with the
drive itself, the system displays an error message. If it
does not find a diskette in the drive, the system then
tries to boot from the hard-disk drive (drive 0).

Selecting

HARD DISK ONLY

causes the system to boot

only from the hard-disk drive, even if there is a boot-
able diskette in drive A.

Setup Password

SETUP PASSWORD

lets you restrict access to your com-

puter’s System Setup program in the same way that you
restrict access to your system with the system password
feature. The options are:

NOT ENABLED

(the default option)

ENABLED

DISABLED BY JUMPER

NOTE: Read “Using the Setup Password Feature” found
later in this chapter for instructions on assigning a setup
password and using or changing an existing setup pass-
word. See “Disabling a Forgotten Password” found later
in this chapter for instructions on disabling a forgotten
setup password.

Auto Power On

AUTO POWER ON

allows you to set the time and days of

the week to turn on the computer system automatically.
You can set

AUTO POWER ON

to turn on the system either

every day or every Monday through Friday.

NOTE: This feature will not work if you shut off your sys-
tem using a power strip or surge protector.

Time is kept in a 24-hour format (hours:minutes). To
change the start-up time, press the right-arrow key to
increase the number in the highlighted field or press the
left-arrow key to decrease the number. If you prefer, you
can type numbers in both of the appropriate fields.

The default for

AUTO POWER ON

is

DISABLED

.

Power Management

For certain types of monitors and most EIDE hard-disk
drives, you can reduce system power consumption by
enabling the power management feature. With

POWER

MANAGEMENT

enabled, these monitors and drives auto-

matically switch into low-power mode during periods of
system inactivity.

POWER MANAGEMENT

can be implemented at three

levels—

MAXIMUM

,

REGULAR

, and

MINIMUM.

(The differ-

ent levels apply to the monitor only; hard-disk drive
operation is the same for all three.) The default setting for
this category is

DISABLED

.