Replacing the bottom logo assembly, Removing the bottom logo assembly, Removing the bottom logo led – Dell Studio Hybrid D140G (Mid 2008) User Manual
Page 7
Back to Contents Page
Replacing the Bottom Logo Assembly
Dell™ Studio Hybrid Service Manual
Removing the Bottom Logo Assembly
Installing the Bottom Logo LED
Installing the Bottom Logo Assembly
Removing the Bottom Logo Assembly
1.
Follow the procedures in
Before You Begin
.
2.
Remove the computer cover (see
Removing the Computer Cover
).
3.
Remove the drive cage (see
Removing the Drive Cage
).
4.
Remove the processor heat sink (see
Removing the Heat Sink
).
5.
Remove the front I/O panel (see
Removing the Front I/O Panel
).
6.
Remove the back panel (see
Removing the Back Panel
).
7.
Remove the system board (see
Removing the System Board
).
8.
Remove the screw that secures the logo bracket to the chassis.
9.
Slide and lift the logo bracket away from the chassis.
Removing the Bottom Logo LED
1.
Pry the LED away from the chassis using a screwdriver.
2.
Lift the LED away from the chassis.
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.