Replacing the rf receiver board, Removing the rf receiver board, Installing the rf receiver board – Dell Studio Hybrid D140G (Mid 2008) User Manual
Page 32
Back to Contents Page
Replacing the RF Receiver Board
Dell™ Studio Hybrid Service Manual
Removing the RF Receiver Board
Installing the RF Receiver Board
Removing the RF Receiver Board
1.
Follow the procedures in
Before You Begin
.
2.
Remove the computer cover (see
Removing the Computer Cover
).
3.
Remove the drive cage (see
Removing the Drive Cage
).
4.
Remove the front panel (see
Removing the Front I/O Panel
).
5.
Remove the screw that fastens the RF receiver board to the front of the chassis.
6.
Lift the RF receiver board away from the chassis.
7.
Disconnect the cable that connects the RF receiver board to the system board.
Installing the RF Receiver Board
1.
Follow the procedures in
Before You Begin
.
2.
Connect the cable to the connector (J2) on the RF Receiver board.
3.
Align the RF receiver board with the groove on the chassis.
4.
Replace the screw that secures the RF receiver board to the front of the chassis.
5.
Replace the front panel (see
Installing the Front I/O Panel
).
6.
Replace the drive cage (see
Installing the Drive Cage
).
7.
Replace the computer cover (see
Installing the Computer Cover
).
Back to Contents Page
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
1
RF receiver board
2
cable
NOTICE:
Carefully note the routing of each cable before you disconnect it, so that you re-route the cable correctly. An incorrectly routed or a
disconnected cable could lead to computer problems.