Dell Studio Hybrid D140G (Mid 2008) - Manual (Page 22)

Back to Contents Page
Replacing the Front I/O Panel
Dell™ Studio Hybrid Service Manual
Removing the Front I/O Panel
Installing the Front I/O Panel
Removing the Front I/O Panel
1. Follow the procedures in Before You Begin .
2. Remove the computer cover (see Removing the Computer Cover ).
3. Remove the drive cage (see Removing the Drive Cage ).
4. Disconnect the flex-cable from the system board, then press the two tabs located on the top and gently pull the front panel away from the chassis.
Installing the Front I/O Panel
1. Follow the procedures in Before You Begin .
2. Connect the flex-cable to the system board (TPB_CON1).
3. Align the four tabs with the corresponding slots on the chassis and gently push the front panel until it snaps into place.
CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE: Carefully note the routing of each cable before you disconnect it, so that you re-route the cable correctly. An incorrectly routed or a
disconnected cable could lead to computer problems.
1 front panel 2 bottom tabs (2)
3 top tabs (2) 4 flex-cable