Dell PowerEdge RAID Controller H200 - Manual (Page 32)

32
Driver Installation
Installing the Windows Driver
This section documents the procedures used to install the Windows driver.
Creating the Driver Media
Perform the following steps to create the driver media:
1 From the Dell Support website at support.dell.com, browse to the
download section for the system.
2 Locate and download the latest PERC H200 or 6Gbps SAS HBA card
driver to the system.
3 Follow the instructions on the Dell Support website for extracting the
driver to the media.
Pre-Installation Requirements
Before you install the operating system:
• Read the Microsoft Getting Started document that ships with your
operating system.
• Ensure that your system has the latest BIOS and firmware. Ensure that the
latest driver is available for the installation. If required, download the latest
BIOS, firmware, and driver updates from the Dell Support website at
support.dell.com.
• Create a device driver media (diskette, USB drive, CD, or DVD).
Creating the Device Driver Media
Use one of the methods described in the following sections to create the
device driver media.
Downloading Drivers From the Dell Systems Service and Diagnostic Tools Media
1 Insert the Dell Systems Service and Diagnostics Tools media into a system.
The Welcome to Dell Service and Diagnostic Utilities screen is displayed.
2 Select your system model and operating system.
3 Click Continue.
PERC H200.book Page 32 Tuesday, July 13, 2010 4:15 PM