Dell PowerEdge RAID Controller H200 - Manual (Page 27)

Hardware Installation
27
7 Tighten the bracket screw, if any, or use the system’s retention clips to
secure the controller to the system’s chassis.
8 For a PERC H200 card, connect the cables from the end devices or the
backplane of the system to the controller. See Figure 4-2.
Figure 4-2. Connecting the Cable for PERC H200
9 For the 6Gbps SAS HBA controller, connect the cable from the external
enclosure to the adapter. See Figure 4-3.
NOTE:
The external cable can be connected to either of the two
external connectors.
1 SAS x4 internal connector 2 cable
3 PERC H200 Card
3
2
1
PERC H200.book Page 27 Tuesday, July 13, 2010 4:15 PM