Dell Inspiron Mini 9 (910, Late 2008) - Manual (Page 25)

Removing the Mini-Card
1. Follow the instructions in Before You Begin .
2. Remove the module cover (see Removing the Module Cover ).
3. Disconnect the antenna cables from the Mini-Card.
4. Release the Mini-Card by removing the securing screws.
5. Lift the Mini-Card out of its system board connector.
Replacing the Mini-Card
1. Follow the instructions in Before You Begin .
2. Remove the new Mini-Card from its packing.
1 Mini-Card 2 securing screw (2)
3 antenna cable connector (2)
NOTICE: When the Mini-Card is not in the computer, store it in protective antistatic packaging. See the information on protection against electrostatic
discharge in the safety information that shipped with your computer.
NOTICE: The connectors are keyed to ensure correct insertion. If you feel resistance, check the connectors on the card and on the system board, and
realign the card.
NOTICE: To avoid damage to the Mini-Card, never place cables under the card.
NOTICE: Use firm and even pressure to slide the card into place. If you use excessive force, you may damage the connector.