Dell Latitude CPi A - Manual (Page 30)

22 Dell Latitude CPiA Service Manual
1. Remove the back cover assembly.
2. Remove the keyboard.
3. Remove the palmrest assembly.
4. Remove the two black 5-mm interface-cable grounding screws and the
interface cable bracket.
5. Disconnect the display-assembly interface cable from connector JP1 on
the system board.
Grasp the grounding tabs and pull the connector straight up from the
system board.
6. Close the display, being careful not to damage the display-assembly
interface cable.
7. Remove the four silver 5-mm screws securing each of the two hinge
brackets to the bottom case assembly.
8. Lift the display assembly from the bottom case assembly.
NOTE: When you reinstall the display assembly, install the four screws
securing the hinges at the locations marked by arrows on the face of each
hinge.
&$87,21:KHQ\RXUHLQVWDOOWKHGLVSOD\DVVHPEO\LQWHUIDFHFDEOH
EHYHU\FDUHIXOQRWWRLQVHUWLWLQWRWKHFRQQHFWRUDWDQDQJOH3RVLWLRQ
WKHFDEOHHQGRYHUWKHFRQQHFWRUDQGSXVKWKHFDEOHHQGVWUDLJKW
GRZQWRSUHYHQWEHQGLQJWKHFRQQHFWRUSLQV