Dell Latitude CPi A - Manual (Page 24)

16 Dell Latitude CPiA Service Manual
.H\ERDUG$VVHPEO\
To remove the keyboard assembly, perform the following steps.
&$87,210DNHVXUHWKHZRUNVXUIDFHLVFOHDQWRSUHYHQWVFUDWFKLQJ
WKHFRPSXWHUFRYHU
1. Close the display assembly, and turn the computer upside down on a flat
work surface (see Figure 9).
)LJXUH5HPRYLQJWKH.H\ERDUG$VVHPEO\6FUHZV
2. Remove the six 12-mm screws securing the keyboard to the computer.
3. Turn the computer right-side up and open the display.
&$87,217KHNH\FDSVRQWKHNH\ERDUGDUHIUDJLOHHDVLO\GLVORGJHG
DQGWLPHFRQVXPLQJWRUHSODFH%HFDUHIXOZKHQUHPRYLQJDQG
KDQGOLQJWKHNH\ERDUG
4. Release the keyboard from the palmrest assembly:
a. Carefully deflect the palmrest (next to the blank key below the
key; see Figure 10) away from the center of the keyboard, until the tab
on the palmrest’s inner edge disengages from the keyboard. The
keyboard should raise up slightly.
b. Insert a fingernail or a small flat-bladed screwdriver under the scalloped
edge of the blank key (see Figure 10), and lift the right edge of the
keyboard.
12-mm screws (6)