Dell Latitude D510 - Manual (Page 72)

If you ordered an internal card with Bluetooth wireless technology with your computer, the card is already installed.
1. Ensure that the work surface is flat and clean to prevent scratching the computer cover.
2. Save and close any open files, exit any open programs, and then shut down the computer.
3. If the computer is connected to a docking device (docked), undock it. See the documentation that came with your docking device for instructions.
4. Disconnect the computer from the electrical outlet.
5. Wait 10 to 20 seconds, and then disconnect any attached devices.
6. Remove any installed PC Cards, batteries, and module bay devices.
7. Remove the Hard Drive .
8. Pull the Bluetooth card connector out of the system board connector.
9. Pull the cable to remove the Bluetooth card from the computer.
To replace a Bluetooth card:
1. Insert the Bluetooth card.
2. Ensure that the cable is routed under the tab.
CAUTION: Before working inside your computer, read the safety instructions in your Product Information Guide.
NOTICE: Handle components and cards by their edges, and avoid touching pins and contacts. Ground yourself by touching a metal connector on the
back of the computer. Continue to ground yourself periodically during this procedure.
1 Bluetooth card
2 system board connector
3 Bluetooth card connector
4 cable
NOTE: When replacing the Bluetooth card, ensure the Bluetooth cable is routed correctly so that you do not damage the cable when you install the hard
drive.