Camera (optional), Removing the camera, Replacing the camera – Dell Studio 1737 (Late 2008) User Manual
Page 10
Back to Contents Page
Camera (optional)
Dell™ Studio 1735/1737 Service Manual
Removing the Camera
1.
Follow the instructions in
Before You Begin
.
2.
Follow the instructions in
Display Assembly
.
3.
Remove the display bezel (see
Display Bezel
).
4.
Pull the camera cable pull-tab to disconnect it from the connector on the camera board.
5.
Remove the two screws securing the camera board.
6.
Remove the camera board.
Replacing the Camera
1.
Align the camera board over the screw holes.
2.
Replace the two screws that secure the camera board to the display.
3.
Connect the camera cable to the connector on the display board.
4.
Replace the display bezel (see
Replacing the Display Bezel
).
5.
Follow the instructions in
Replacing the Display Assembly
.
Back to Contents Page
CAUTION:
Before working inside your computer, follow the safety instructions that shipped with your computer.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface
(such as a connector on the back of the computer).
1
camera
2
camera cable pull-tab
3
screw (2)