Dell Vostro 1710 (Early 2008) - Manual (Page 64)

1 battery latch assembly 2 battery release button
3 spring
Replacing the Battery Latch Assembly
CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your
computer.
NOTICE: Ensure the battery latch assembly is properly oriented. The indent for the screw should face up
when installing the assembly.
This procedure assumes that you have completed the removal procedure Removing the Battery Latch Assembly .
1. Ensure that the battery latch spring is properly mounted on the guide post of the battery latch assembly.
2. Align the battery release button with the hole in the battery latch assembly, then press the button into place.
3. Replace the M2 x 3-mm screw that holds the battery release button in the battery latch assembly.
4. Align the guide post on the battery latch assembly with the slot on the base of the computer, then lower the latch
assembly into place.
NOTICE: The battery release button is keyed to ensure proper alignment. If you feel resistance, check the
alignment of the release button.
5. Replace the system board (see Replacing the System Board Assembly ).
6. Connect the cable that secures the internal card with Bluetooth wireless technology to the system board (see Replacing
the Card ).
7. Replace the optical drive (see Replacing the Optical Drive ).
8. Replace the palm rest (see Replacing the Palm Rest ).
9. Replace the display assembly (see Replacing the Display Assembly ).
10. Replace the keyboard (see Replacing the Keyboard ).
11. Replace the hinge cover (see Replacing the Hinge Cover ).
12. Replace the fan (see Replacing the Fan ).