Dell Vostro 1710 (Early 2008) - Manual (Page 42)

Replacing the Display Bezel
CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your
computer.
This procedure assumes that you have completed the removal procedure Removing the Display Bezel .
1. Starting at any corner, use your fingers to gently snap the bezel into place to secure it to the top cover.
2. Replace the four M2.5 x 5-mm screws and the four shoulder screws in the display bezel.
3. Replace the eight rubber display bumpers around the display bezel.
4. Replace the display assembly (see Replacing the Display Assembly ).
5. Replace the keyboard (see Replacing the Keyboard ).
6. Replace the hinge cover (see Replacing the Hinge Cover ).
7. Reconnect the antenna to the WLAN card (see Replacing a WLAN Card ).
Display Panel
Removing the Display Panel
CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your
computer.
1. Follow the instructions in Before Working on Your Computer .
2. Disconnect the antenna from the WLAN card (see Removing a WLAN Card ).
3. Remove the hinge cover (see Removing the Hinge Cover ).
4. Remove the keyboard (see Removing the Keyboard ).
5. Remove the display assembly (see Removing the Display Assembly ).
6. Remove the display bezel (see Removing the Display Bezel ).
7. Remove the two M2.5 x 5-mm screws from the display hinges.
8. Lift the top edge of the display panel assembly away from the top cover.
9. Remove the eight M2 x 3-mm screws from the display panel.