CyberResearch CPEX P4-24-X - Manual (Page 33)

CyberResearch
®
CPU Cards CPEX Series
CyberResearch, Inc. 21
25 Business Park Drive P: (203) 483-8815; F: (203) 483-9024
Branford, CT USA www.cyberresearch.com
Chapter3 AMI BIOS SETUP
3.1 Introduction
This manual describes AMI's Setup program, which is built into the ROM BIOS. The
Setup program allows users to modify the basic system configuration. This special
information is then stored in battery-backed RAM so that it retains the Setup
information when the power is turned off.
3.2 Starting Setup
The AMI BIOS is immediately activated when you first power on the computer. The
BIOS reads the system information contained in the CMOS and begins the process
of checking out the system and configuring it. When it finishes, the BIOS will seek an
operating system on one of the disks and then launch and turn control over to the
operating system.
While the BIOS is in control, the Setup program can be activated in one of two ways:
1. By pressing immediately after switching the system on, or
2. by pressing the key when the following message appears briefly at the
bottom of the screen during the POST.
Press DEL to enter SETUP.
If the message disappears before you respond and you still wish to enter Setup,
restart the system to try again by turning it OFF then ON or pressing the "RESET"
button on the system case. You may also restart by simultaneously pressing ,
, and keys. If you do not press the keys at the correct time and the
system does not boot, an error message will be displayed and you will
again be asked to...
3.3 Using Setup
In general, you use the arrow keys to highlight items, press to select, use
the PageUp and PageDown keys to change entries, press for help and press
to quit. The following table provides more detail about how to navigate in the
Setup program using the keyboard .
Up arrow Move to previous item
Down arrow Move to next item
Left arrow Move to the item in the left hand
Right arrow Move to the item in the right hand