Crestron electronic RS-232/42 - Manual (Page 20)

Ethernet RS-232/422 COM Module Crestron CEN-COM
System View of the CEN-COM in SIMPL Windows’ Configuration Manager
For this example, a real COM port is used rather than a virtual COM port. To assign
a real COM port, select the ST-COM from the Serial Drivers (General) folder in the
Device Library. Drag the icon over to Port A in the Detail System View. The result is
shown below.
COM Port Assignment Displayed in the Detail System View Area of SIMPL Windows’
Configuration Manager
Programming Manager
Use the Programming Manager workspace (Project | Program System) in SIMPL
Windows to select symbols and assign their respective signals. For this example, a
touchpanel and CEN-COM symbol were added automatically when the devices were
added to the system in the Configuration Manager workspace. Expand the Network
Modules folder and double click on the CT-3500 for a detail view (alternatively
CTRL+D or drag and drop into Detail View). Assign the signal as shown after this
paragraph.
Detail View of the CT-3500 in SIMPL Windows’ Programming Manager
16 • Ethernet RS-232/422 COM Module: CEN-COM Operations Guide - DOC. 5719