Optical drive, Internal card with bluetooth® wireless technology, Reinstall the optical drive. see – Dell Precision M90 User Manual
Page 68

5.
Install the replacement battery:
a.
Insert the battery at a 30-degree angle under the release latch with the positive side up, and then push the battery into place.
b.
Connect the battery cable to the connector on the system board.
6.
7.
Optical Drive
1.
.
2.
Turn the computer over.
3.
Remove the optical-drive security screw.
4.
Insert a scribe into the notch and push it to the side to release the drive from the bay.
5.
Slide the drive out of the bay.
To reinstall the optical drive, slide the drive into the drive bay and snap it into place. Then replace the optical-drive security screw.
Internal Card With Bluetooth® Wireless Technology
If you ordered a card with Bluetooth wireless technology with your computer, it is already installed.
1.
.
2.
Remove the battery. See
Replacing the Battery
.
3.
Remove the cover screw and remove the card cover from the computer.
4.
Pull the card out of the compartment so that you can disconnect the card from its cable and remove it from the computer.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
1
notch
2
optical-drive security screw
3
optical drive
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as a connector on the back of the computer).
NOTICE:
To avoid damaging the system board, you must remove the battery before you begin working inside the computer.