Dell Latitude Cpi - Manual (Page 42)

36 Dell Latitude CP and CPi — Parts Removal and Replacement Guide
3. Remove the four silver 5-mm screws securing the two hinge brackets
to the display-assembly top cover.
NOTES: To aid in reinstalling the hinges and display assembly, the right and left
hinges are marked by an “R” and an “L,” respectively. Install the four screws
securing the hinges at the locations marked by arrows on the face of each
hinge.
The right bracket on a 12.1-inch display fits above the right hinge (see
Figure 14).
!
!
1. Remove the display assembly bezel.
2. Remove the display assembly.
3. Remove the LCD panel.
4. Remove the LCD inverter board.
5. Remove the display assembly latch.
6. Remove the left and right hinges.
7. Remove the right bracket (12.1-inch display only).
8. Remove the display-assembly interface cable.
9. If you are removing the display-assembly top cover from a 13.3-inch
display, remove the right and left braces.
To remove a brace, remove the 3-mm screw securing the brace to the
display-assembly top cover.
NOTES: The replacement display-assembly top cover assembly includes two
badges, one for Dell Latitude CP and one for the Dell Latitude CPi. Look at
the old cover to determine which badge is appropriate, and then attach the
appropriate badge to the new cover.
When reinstalling the display assembly, install the four screws securing the
hinges at the locations marked by arrows on the face of each hinge.
The bottom case assembly consists of the following field-replaceable
components:
Diskette drive assembly, CD-ROM drive assembly, or travel module
Back cover assembly
Audio shield
Audio board