Dell Latitude Cpi - Manual (Page 28)

22 Dell Latitude CP and CPi — Parts Removal and Replacement Guide
5. Turn the computer right-side up on the work surface, and open the
display assembly 180 degrees.
NOTE: Support the display assembly with a book or similar object so that
the display assembly does not open beyond 180 degrees.
6. Carefully remove the palmrest assembly from the bottom case
assembly.
The palmrest assembly is secured in the bottom case assembly by four
snaps and tabs on the right and left ends of the palmrest. Take care not to
damage the snaps when removing the palmrest.
NOTE: When replacing the palmrest, ensure that the vertical tab at the back
of the palmrest fits on the outside of the system board assembly, near the
parallel port connector. Also, check that the microphone boot is properly
located in its slot on the top EMI shield and is fitted within the palmrest
assembly.