Dell POWEREDGE M1000E - Manual (Page 19)

Rev 1.00
19
mismatch - both uplink and downlink are connected, but there is a mismatch
10G - uplink and downlink are connected at 10GbE
• Downlink port link state:
- down: blade not present
- 10G: 10GbE link
• Detailed downlink port link states (available in ADMIN level only):
- 10G KR [AN]: 10GBASE-KR link;
AN indicates that 802.3ap autonegotiation is active
• Uplink port link state:
- empty: No module present
- module_type [no link]: Module is present (module type is shown);
no link: optical fiber cable is disconnected
Example:
# show port link
Port
Group Connect Downlink Uplink Status
--------------------------------------------------------------
1
A (10G) 10G 10G SFP+ SR Link Up
2 A (10G) 10G 10G SFP+ SR Link Up
3 A (10G) 10G 10G SFP+ LR Link Up
4 A (10G) 10G 10G SFP+ SR Link Up
5 A (10G) 10G 10G SFP+ SR Link Up
6 A (10G) mismatch 10G SFP SX Link Down
7 A (10G) down down SFP+ SR Link Down
8 A (10G) down down empty
9 B (10G) mismatch 10G SFP SX Link Down
10 B (10G) mismatch 10G SFP SX Link Down
11 B (10G) mismatch 10G SFP SX Link Down
12 B (10G) mismatch 10G SFP LX Link Down
13 B (10G) down down empty
14 B (10G) down 10G SFP+ SR Link Down
15 B (10G) mismatch 1G SFP+ SR Link Down
16 B (10G) mismatch 1G SFP+ SR Link Down
#
# show port link 7
Port
Group Connection Downlink Uplink Status
--------------------------------------------------------------
7
A (10G) down down SFP+ SR Link Down
#
3.7.3 show port module
Synopsys:
show port module port_number
Description:
Show the transceiver module information for the specified uplink port.