Dell POWEREDGE M1000E - Manual (Page 25)

Rev 1.00
25
chassisaction –m switch- powercycle
where is the switch number [1-6].
5.3 Resolving a Link Protocol Mismatch
Log in to 10GbE PTM CLI and run the “show port link” command. Check the status of the down-
link and uplink in the relevant port to identify the mismatch – see
Section 3.7.2 for details.
5.4 Resolving CLI Connectivity Problems
Reboot the 10GbE PTM through the CMC CLI using the following command:
chassisaction –m switch- powercycle
where is the switch number [1-6].
5.5 Recovery From Non-Responsive 10GbE PTM CLI
Reboot the 10GbE PTM through the CMC CLI using the following command:
chassisaction –m switch- powercycle
where is the switch number [1-6].
5.6 Recovery From a Software Update Failure
1. Reboot the 10GbE PTM through the CMC CLI using the following command:
chassisaction –m switch- powercycle
where is the switch number [1-6].
2. Restart the software update process.