Dell POWEREDGE M1000E - Manual (Page 13)

Rev 1.00
13
3 Command Line Interface (CLI) Reference
10GbE PTM management is done via the 10GbE PTM CLI. You can use the commands described
in this section after successfully connecting to the 10GbE PTM CLI according to the procedure
described in
Section 2, “Connecting to the 10GbE PTM CLI,” on page 9 .
3.1 CLI Privilege Levels
The 10GbE PTM supports the following user privilege levels:
• USER - Common user level, indicated by the # prompt
• ADMIN - Administrator level, indicated by the & prompt
Different commands are available in different privilege levels. The command reference indicates
the required privilege level for each command that requires a privilege level higher than USER.
3.2 Quick Reference
Table 5 provides a quick reference to the CLI commands:
Table 5 - List of Commands
Command
name
Short Description Reference
General Commands
help Shows the list of available commands Section 3.4.1, “help,” on page 14
login Change privilege level Section 3.4.2, “login (ADMIN),” on
page 15
exit Exit current privilege level Section 3.4.3, “exit,” on page 15
reload Restart the module:
Hardware reset and software reload
Section 3.4.4, “reload,” on page 15
Software Image Commands
show image ver Shows the software image version Section 3.5.1, “show image ver,” on
page 16
copy image from-
file Upload new software image to the PTM Section 3.5.2, “copy image from-file,”
on page 16
Device Commands
show device temp Shows the temperature of a specified device Section 3.6.1, “show device temp
(ADMIN),” on page 17
Port Commands