beautypg.com

Changing boot sequence for future boots, Clearing forgotten passwords – Dell Inspiron 530s (Mid 2007) User Manual

Page 190

background image

190

Appendix

3 When

F2 = Setup, F12 = Boot Menu

appears in the upper-right

corner of the screen, press .

If you wait too long and the operating system logo appears, continue to
wait until you see the Microsoft Windows desktop. Then, shut down your
computer and try again.
The Boot Device Menu appears, listing all available boot devices.
Each device has a number next to it.

4 At the bottom of the menu, enter the number of the device that is to be

used for the current boot only.

For example, if you are booting to a USB memory key, highlight USB
Flash Device and press .

NOTE:

To boot to a USB device, the device must be bootable. To ensure your

device is bootable, check the device documentation.

Changing Boot Sequence for Future Boots

1 Enter system setup (see "Entering System Setup" on page 185).
2 Use the arrow keys to highlight the Boot Sequence menu option and press

to access the menu.

NOTE:

Write down your current boot sequence in case you want to restore it.

3 Press the up- and down-arrow keys to move through the list of devices.
4 Press the spacebar to enable or disable a device (enabled devices have

a checkmark).

5 Press plus (+) or minus (–) to move a selected device up or down the list.

Clearing Forgotten Passwords

CAUTION:

Before you begin any of the procedures in this section, follow the

safety instructions located in the Product Information Guide.

1 Follow the procedures in "Before You Begin" on page 103.
2 Remove the computer cover (see "Removing the Computer Cover" on

page 105).

3 Locate the 3-pin password connector (PSWD) on the system board.

NOTE:

The location of the password connector may vary depending on the system.

book.book Page 190 Monday, October 6, 2008 11:38 AM