Dell Inspiron 530s (Mid 2007) - Manual (Page 134)

134
Removing and Installing Parts
6 Replace the support bracket (see "Replacing the Support Bracket" on
page 173), and then press down the card retention bracket to seat it on its slot.
7 Ensure that:
• The guide clamp is aligned with the guide notch.
• The tops of all cards and filler brackets are flush with the alignment bar.
• The notch in the top of the card or filler bracket fits around the
alignment guide.
8 Replace the computer cover, reconnect the computer and devices to
electrical outlets, and then turn them on.
9 Remove the card’s driver from the operating system.
10 If you removed a sound card:
a Enter system setup (see "System Setup" on page 185), go to Onboard
Devices and select Integrated Audio and then change the setting to On.
b Connect external audio devices to the audio connectors on the back
panel of the computer. See "Back Panel Connectors" on page 23.
11 If you removed an add-in network connector:
a Enter system setup (see "System Setup" on page 185), go to Onboard
Devices, and select Integrated NIC, and then change the setting to On.
NOTICE:
To connect a network cable, first plug the cable into the network
device and then plug it into the computer.
b Connect the network cable to the integrated connector on the back
panel of the computer. See "Inspiron 530sa/530sc" on page 19 and
"Inspiron 530sb/530sd" on page 21.
book.book Page 134 Monday, October 6, 2008 11:38 AM