Replacing the system board – Dell Studio 1569 (Late 2009) User Manual
Page 43
16.
Carefully ease the connectors on the system board out of the computer base and lift the system board assembly out of the computer base.
17.
Turn the system board assembly over.
18.
Follow the instructions from
step 4
to
step 5
in
Removing the Coin-Cell Battery
.
19.
Remove the processor heat sink (see
Removing the Processor Heat Sink
).
20.
Remove the processor module (see
Removing the Processor Module
).
Replacing the System Board
1.
Follow the procedures in
Before You Begin
.
2.
Replace the processor module (see
Replacing the Processor Module
).
3.
Replace the processor heat sink (see
Replacing the Processor Heat Sink
).
4.
Ensure that the Mini-Card antenna cables are attached to the computer base.
5.
Follow the instructions from
step 2
to
step 3
in
Replacing the Coin-Cell Battery
.
6.
Connect the hard drive cable and the USB cable to the system board connectors.
7.
Turn the system board assembly over and align the connectors on the system board with the slots in the computer base.
8.
Connect the display cable to the system board connector.
9.
Connect the audio cable to the system board connector.
10.
Replace the three screws that secure the system board to the computer base.
11.
Replace the speakers (see
Replacing the Speakers
) and route the USB cable in the routing guides on the right speaker.
12.
Replace the processor fan (see
Replacing the Processor Fan
).
13.
Replace the optical drive (see
Replacing the Optical Drive
).
14.
Replace the hard drive (see
Replacing the Hard Drive
).
1
system board assembly
2
screws (3)
3
pull-tab
4
display cable
5
USB cable
6
pull-tab
7
computer base
8
hard drive cable
9
pull-tab