Display bezel, Replacing the display assembly, Removing the display bezel – Dell Studio 1569 (Late 2009) User Manual
Page 17
Replacing the Display Assembly
1.
Follow the procedures in
Before You Begin
.
2.
Use the alignment posts to place the display assembly on the computer base.
3.
Replace the five screws that secure the display assembly to the computer base.
4.
Replace the display cable grounding screw in the display hinge.
5.
Route the Mini-Card antenna cables in the routing guides on the computer base.
6.
Follow the instructions from
step 4
to
step 23
in
Replacing the System Board
.
7.
Replace the battery (see
Replacing the Battery
).
Display Bezel
Removing the Display Bezel
1.
Follow the procedures in
Before You Begin
.
2.
Remove the display assembly (see
).
3.
Remove the four rubber pads that cover the display bezel screws.
4.
Remove the fours screws that secure the display bezel to the display assembly.
5.
Carefully pull up along the edges of the display bezel to remove it from the display assembly.
1
Mini-Card antenna cables
2
computer base
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
CAUTION:
The display bezel is extremely fragile. Be careful when removing it to prevent damaging the bezel.