Display, Display assembly, Removing the display assembly – Dell Studio 1569 (Late 2009) User Manual
Page 16
Back to Contents Page
Display
Dell™ Studio™ 1569 Service Manual
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the
Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
Display Assembly
Removing the Display Assembly
1.
Follow the procedures in
Before You Begin
.
2.
Remove the battery (see
Removing the Battery
).
3.
Follow the instructions from
step 3
to
step 16
in
Removing the System Board
.
4.
Make a note of the Mini-Card antenna cable routing and remove the antenna cables from the routing guides on the computer base.
Pull the cables away so that they are clear of the computer base.
5.
Remove the five screws that secure the display assembly to the computer base.
6.
Remove the display cable grounding screw from the display hinge.
7.
Lift the display assembly off the alignment posts on the computer base.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface.
CAUTION:
To help prevent damage to the system board, remove the main battery (see
Removing the Battery
) before working inside the
computer.
1 display assembly
2 screws (5)
3 Mini-Card antenna cables
4 display cable grounding screw
5 display hinges (2)