Dell Inspiron 9200 - Manual (Page 48)

4. Turn the system top side up.
5. Remove the hinge cover .
6. Open the display all the way (180 degrees) so that it lies flat against the work surface.
7. Use the pull-tab to disconnect the display cable.
8. Remove the four M2.5 x 5-mm screws (two on each side) that connect the LCD display to the system.
9. Lift the display out of the computer.
Replacing the Display Assembly
1. Align the display assembly over the screw holes in the base of the system.
2. Replace the four M2.5 x 5-mm screws.
3. Thread the Mini PCI antenna cables back through the hole in the base of the system.
1 antenna cables
NOTE: When removing the display, carefully thread the Mini-PCI antenna cables through the system base.
1 display cable pull-tab
2 M2.5 x 5-mm screws (4)
3 antenna cables (2)
4 display cable connector