Dell PowerVault 745N - Manual (Page 17)

Rack Installation Guide
17
Figure 9. Opening the Wire Covers
7 Route the status-indicator end of the cable assembly through the cable-management arm, and
install the indicator in its slot at the back end of the cable-management arm (see Figure 9).
8 Connect the power cords to their receptacles on the back panel.
NOTICE:
Although the strain-relief can accommodate power cords with a bend radius of up to
19 mm (0.75 inch), the system manufacturer recommends that you only use the power cords provided
with the system.
9 Install a tie-wrap through the slot on the strain-relief tab (see Figure 10).
10 Bend the power cords back beside the power receptacle housing, forming a tight loop, and
install the strain-relief tie-wrap loosely around the looped power cords (see Figure 10).
NOTE: The power cord strain-relief tab is not applicable to all systems.
status-indicator cable plug
wire covers in
open position
status indicator