Dell PowerVault MD3220i - Manual (Page 72)

72 Appendix—Manual Configuration of iSCSI
If you are using Windows Server 2008 Core Version:
1 Set the iSCSI initiator services to start automatically (if not already set):
sc \\ config msiscsi start= auto
2 Start the iSCSI service (if necessary): sc start msiscsi
3 Log on to the target:
iscsicli PersistentLoginTarget
* * *
* * * * *
*
where
–
is the target name as displayed in the target list. Use
the iscsicli ListTargets command to display the target list.
– is T, which exposes the LUN to the operating
system as a storage device.
– is the IP address of the iSCSI port on the
controller being logged in to.
– is 3260.
– is 0x2 to enable multipathing for the target on the
initiator. This value allows more than one session to be logged in to a
target at one time.
– is the initiator name.
– is the target CHAP secret.
– is either 0 for no authentication, 1 for Target CHAP, or 2
for Mutual CHAP.
: NOTE: , and are optional parameters.
They can be replaced with an asterisk (*) if CHAP is not used.
– is 0, indicating that no mappings are specified
and no further parameters are required.
* * * An asterisk (*) represents the default value of a parameter.
book.book Page 72 Sunday, September 11, 2011 10:24 PM