Dell PowerVault MD3220i - Manual (Page 43)

Post Installation Tasks 43
If you have not selected Specify Configuration Manually for any of the
two protocols, then you can skip step 8.
8 If you have selected Specify Configuration Manually for any of the two
protocols in the last step, a series of screens showing the backend view
image of the storage array controllers is displayed. Each image contains IP
addresses of management ports of the controllers. Also each image has one
management port highlighted in red.
For IPv4 address of the highlighted port, enter the IP address, subnet
mask and gateway address in the fields shown below the image in order
to modify it.
For IPv6 address of the highlighted port, enter the local IP address,
routable IP, and router IP address in the fields shown below the image in
order to modify it.
Click
Next to continue through these images to complete the
configuration of all the management ports for the selected protocols.
9 In the CHAP Configuration screen, select the CHAP method and click
Next. For more information on CHAP see "Understanding CHAP
Authentication" on page 63.
10 In the Summary screen, review the information that you entered for the
storage array.
Click
Apply to save the changes to the storage array.
NOTE: To abort the configuration for the storage array and to go back to
select a storage array for configuration, click Cancel Array.
11 On the Configure Additional Arrays screen, select whether you want to
configure additional array. Click Next to continue.
12 If you selected Yes in the above step, then start again from step 4.
13 If you selected No in step 12, then on the Configure Host Connectivity
screen, select whether you want to configure the connectivity for current
host’s iSCSI initiator. Click Next to continue.
If you selected No above, then you are done with the configuration task.
14 Click Finish on the final screen to exit the utility.
book.book Page 43 Sunday, September 11, 2011 10:24 PM