Dell PowerVault MD3220i - Manual (Page 44)

44 Post Installation Tasks
15 If you selected Yes in the last step, then the Select Storage Array screen is
displayed. Select the storage array that you want to configure for
connectivity to the local host.
NOTE: The storage arrays configured by the utility are marked as
Configuration Complete against their names in the list. This helps you to
identify the arrays that are ready to be configured for host access.
16 In the Storage Array Login screen, in the Controller# column, select the
iSCSI host port of the storage array that needs to be configured and it’s IP
address(es). In the Host Address column, from drop-down menu list,
select the host IP address that will login to the iSCSI host port of the
storage array.
See "Source Port Selection for iSCSI Host Ports" on page 46’ for more
information about how these host IP addresses are listed in the drop-down
menu and the recommended guidelines for selecting the host IP addresses.
Click
Next to continue to enter the log in information for another
controller or Click Apply to save the log in information.
17 In the Connect to Additional Arrays screen, select whether you want to
connect to another storage array or not.
If you want to connect to another storage array, repeat the above steps
starting from step 15.
If you do not want to connect to additional arrays, then click
Finish on the
final screen to exit the utility.
book.book Page 44 Sunday, September 11, 2011 10:24 PM