Dell PowerVault MD3220i - Manual (Page 70)

70 Appendix—Manual Configuration of iSCSI
discovery.sendtargets.auth.username = iqn.1984-
05.com.dell:powervault.123456
discovery.sendtargets.auth.password_in =
test1234567890
If you are using SUSE Linux Enterprise Server SP3 using the GUI:
1 Click DesktopYaSTiSCSI Initiator.
2 Click Service Start, then select When Booting.
3 Select Discovered Targets, then select Discovery.
4 Enter the IP address of the port.
5 Click Next.
6 Select any target that is not logged in and click Log in.
7 Select one:
• If you are not using CHAP authentication, select No Authentication.
Go to step 8.
or
• If you are using CHAP authentication, enter the CHAP user name and
password. To enable Mutual CHAP, select and enter the Mutual
CHAP user name and password.
8 Repeat step 7 for each target until at least one connection is logged in for
each controller.
9 Go to Connected Targets.
10 Verify that the targets are connected and displays a status of true.
Step 7: Connect to the Target Storage Array From
the Host Server
If you are using Windows Server 2008 GUI:
1 Click Start Programs Microsoft iSCSI Initiator or click Start All
Programs Administrative Tools iSCSI Initiator.
2 Click the Targets tab.
If previous target discovery was successful, the iqn of the storage array
should be displayed under Targets.
book.book Page 70 Sunday, September 11, 2011 10:24 PM