Dell Dimension 5000 - Manual (Page 90)

90
Removing and Installing Parts
www
.dell.com | support.dell.com
Removing a Media Card Reader
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions
located in the Product Information Guide.
NOTICE:
To prevent static damage to components inside your computer, discharge static electricity
from your body before you touch any of your computer’s electronic components. You can do so by
touching an unpainted metal surface on the computer chassis.
1 Follow the procedures in "Before You Begin" on page 53.
2 Lay the computer on its side so that the system board is on the bottom of the inside of the
computer.
3 Remove the computer cover (page 59).
4 Remove the drive panel (see page 76).
5 Disconnect the USB cable on the back of the Media Card Reader to the front panel USB
connector on the system board (see page 61) and route the cable through the clip on the
shroud.
cable
*Media Card Reader
*
Not present on all computers.
C7565bk1.book Page 90 Wednesday, January 26, 2005 1:37 PM