Keyboard, Remove the – Dell Latitude D610 User Manual
Page 79
To replace the hard drive in the hard drive bay:
1.
2.
Turn the computer over, and remove the hard drive screws.
3.
Slide the hard drive out of the computer.
4.
Remove the new drive from its packaging.
Save the original packaging for storing or shipping the hard drive.
5.
Slide the hard drive into the bay until it is fully seated.
6.
Replace and tighten the screws.
7.
Use the Operating System CD to install the
operating system
for your computer.
8.
Use the Drivers and Utilities CD to install the
drivers and utilities
for your computer.
Keyboard
1.
Follow the instructions in "
."
2.
Turn the computer right-side up and open it.
NOTICE:
Hard drives are extremely fragile; even a slight bump can damage the drive.
NOTE:
Dell does not guarantee compatibility or provide support for hard drives from sources other than Dell.
1 screws (2)
2 hard drive
NOTICE:
When the hard drive is not in the computer, store it in protective antistatic packaging. See "Protecting Against Electrostatic Discharge" in the
Product Information Guide.
NOTICE:
Use firm and even pressure to slide the drive into place. If you use excessive force, you may damage the connector.
CAUTION:
Before performing the following procedures, read the safety instructions in your Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.