Dell POWEREDGE M1000E - Manual (Page 27)

Fabric OS v7.1.0a Release Notes v1.0 Page 27 of 41
Fabric OS v7.1 software is fully qualified and supports the blades for the DCX 8510-8 and DCX 8510-4 noted in
the table below.
DCX 8510-8/DCX 8510-4 Blade Support Matrix
FC16-32, FC16-48 16G FC blades Supported starting with FOS v7.0
FC8-64 64 port 8Gbit port blade With any mix and up to 8/4 of each. No restrictions
around intermix.
Note: FC8-16, FC8-32, FC8-48 blades are not
supported on DCX 8510 platforms
FC8-32E, FC8-48E Condor3 based 8G blades Supported starting with FOS v7.0.1 1
FC10-6 Not supported.
Intelligent blade Up to a total of 8/4 intelligent blades. See below for
maximum supported limits of each blade.
FCIP/FC Router blade (FR4-18i) Not supported.
Virtualization/Application Blade (FA4-18) Not supported
Encryption Blade (FS8-18) Up to a maximum of 4 blades of this type.
Next Generation Distance Extension Blade (FX8-24) Up to a maximum of 4 blades of this type.
FCoE/L2 CEE blade FCOE10-24 Not supported
Table 2 Blade Support Matrix for DCX 8510-8 and DCX 8510-4 with FOS v7.1
Note: The iSCSI FC4-16IP blade is not qualified for the DCX 8510-8/DCX 8510-4.
1. Note that 16G SFP+ is not supported in FC8-32E and FC8-48E blades