beautypg.com

Blade support – Dell POWEREDGE M1000E User Manual

Page 26

background image

Fabric OS v7.1.0a Release Notes v1.0

Page 26 of 41

Zoning Compatibility Note:

Users are recommended to upgrade to the following versions of firmware when interoperating with a switch
running FOS v7.0 or later in the same layer 2 fabric to overcome some of the zoning operations restrictions
that otherwise exist:

Main code level

Patch code levels with full zoning

compatibility

FOS v6.2

FOS v6.2.2d or later

FOS v6.3

FOS v6.3.2a or later

FOS v6.4

FOS v6.4.1 or later

If there are switches running FOS versions lower than the above listed patch levels in the same fabric as a
switch with FOS v7.0 or later, then cfgsave and cfgenable operations initiated from these switches will fail if
the zoning database is greater than 128KB. In such scenarios zoning operations such as cfgsave/cfgenable
can still be performed successfully if initiated from a switch running FOS v7.0 or later.

Blade Support

Fabric OS v7.1.0 software is fully qualified and supports the blades for the DCX/DCX-4S noted in the following
table

:

DCX/DCX-4S Blade Support Matrix

16-, 32-, 48- and 64-port 8Gbit port blades (FC8-16,
FC8-32, FC8-48, FC8-64)

Supported with FOS v6.0 and above (FC8-64 requires
FOS v6.4) with any mix and up to 8/4 of each. No
restrictions around intermix.

Intelligent blade

Up to a total of 8/4 intelligent blades. See below for
maximum supported limits of each blade.

6 port 10G FC blade (FC10-6)

Not supported on FOS v7.1 or later

FCIP/FC Router blade (FR4-18i)

Not supported on FOS v7.1 or later

Virtualization/Application Blade (FA4-18)

Not supported on FOS v7.0 or later

Encryption Blade (FS8-18)

Up to a maximum of 4 blades of this type.

Next Generation Distance Extension Blade (FX8-24)

Up to a max of 4 blades of this type.
Note: FR4-18i cannot coexist with FX8-24 in FOS v7.0
or later

FCoE/L2 CEE blade FCOE10-24

Up to a max of 4 blades of this type. Not supported in
the same chassis with other intelligent blades or the
FC8-64 port blade.

FC16-32, FC16-48

Not supported

Table 1 Blade Support Matrix for DCX and DCX-4S with FOS v7.1

Note: The iSCSI FC4-16IP blade is not qualified for the DCX/DCX-4S.