Cadillac 2011 Escalade ESV - Manual (Page 312)

Black plate (106,1) Cadillac Escalade/Escalade ESV Owner Manual - 2011
7-106 Infotainment System
Using the “Dial” or “Call”
Command
1. Press and hold
b g
for
two seconds.
2. Say “Dial” or “Call.”
3. Say the entire number without
pausing, or say the name tag.
Once connected, the person called
will be heard through the audio
speakers.
Using the “Digit Dial” Command
The digit dial command allows a
phone number to be dialed by
entering the digits one at a time.
After each digit is entered, the
system repeats back the digit it
heard followed by a tone.
If an unwanted number is
recognized by the system, say
“Clear” at any time to clear the
last number.
To hear all of the numbers
recognized by the system,
say “Verify” at any time.
1. Press and hold
b g
for
two seconds.
2. Say “Digit Dial.”
3. Say each digit, one at a time,
that you want to dial. After each
digit is entered, the system
repeats back the digit it heard
followed by a tone. After the
last digit has been entered,
say “Dial.”
Once connected, the person called
will be heard through the audio
speakers.
Using the “Re‐dial” Command
1. Press and hold
b g
for
two seconds.
2. After the tone, say “Re‐dial.”
Once connected, the person called
will be heard through the audio
speakers.
Receiving a Call
When an incoming call is received,
the audio system mutes and a ring
tone is heard in the vehicle.
. Press b g to answer the call.
. Press
c x
to ignore a call.
Call Waiting
Call waiting must be supported on
the cell phone and enabled by the
wireless service carrier.
. Press
b g
to answer an
incoming call when another
call is active. The original call
is placed on hold.
. Press
b g
again to return to the
original call.
. To ignore the incoming call, no
action is required.
. Press
c x
to disconnect the
current call and switch to the call
on hold.