Dell 3330dn Mono Laser Printer - Manual (Page 99)

Menu item Description
Quiet Mode
Off
On
Reduces the amount of noise produced by the printer
Notes:
• Off is the factory default setting.
• On configures the printer to produce as little noise as possible.
Run Initial setup
Yes
No
Instructs the printer to run the setup wizard
Notes:
• Yes is the factory default setting.
• After completing the setup wizard by selecting Done at the
Country select screen, the default setting becomes No.
Paper Sizes
US
Metric
Sets paper sizes to use the standard US sizes, which may also be
used in other countries, or to use metric sizes
Notes:
• US is the factory default setting.
• Changing this setting also changes the Units of Measurement
setting in the Univeral Setup menu and the default size value
for each paper source (tray or feeder) in the Paper Size/Type
menu.
Alarms
Cartridge Alarm
Off
Single
Sets an alarm to sound when the printer requires operator
intervention
Notes:
• Off is the factory default setting for Cartridge Alarm. Off means
no alarm will sound. Cartridge low appears on the
display.
• Single sounds three quick beeps. 88 Cartridge is
low
appears on the display.
Timeouts
Power Saver
1min–240 min
Sets the amount of time the printer waits after a job is printed
before it goes into a reduced power state
Notes:
• 30 minutes is the factory default setting.
• Lower settings conserve more energy, but may require longer
warm-up times.
• Select the lowest setting if the printer shares an electrical
circuit with room lighting or you notice lights flickering in the
room.
• Select a high setting if the printer is in constant use. Under
most circumstances, this keeps the printer ready to print with
minimum warm-up time.
Timeouts
Screen Timeout
15 sec–300 sec
Sets the amount of time in seconds the printer waits before
returning the printer display to a Ready state
Note: 30 seconds is the factory default setting.
Understanding printer menus
99