Dell 3330dn Mono Laser Printer - Manual (Page 139)

Job takes longer than expected to print
These are possible solutions. Try one or more of the following:
R
EDUCE THE COMPLEXITY OF THE PRINT JOB
Reduce the number and size of fonts, the number and complexity of images, and the number of pages in the job.
C
HANGE THE
P
AGE
P
ROTECT SETTING TO
O
FF
1 From the printer control panel, press .
2 Press the down arrow button until Settings appears, and then press .
3 Press the down arrow button until General Settings appears, and then press .
4 Press the down arrow button until Print Recovery appears, and then press .
5 Press the down arrow button until Page Protect appears, and then press .
6 Press the down arrow button until Off appears, and then press .
Job prints from the wrong tray or on the wrong paper
C
HECK THE
P
APER
T
YPE SETTING
Make sure the Paper Type setting matches the paper loaded in the tray.
Incorrect characters print
Make sure the printer is not in Hex Trace mode. If Ready Hex appears on the display, you must exit Hex Trace mode
before you can print your job. Turn the printer off and back on to exit Hex Trace mode.
Tray linking does not work
L
OAD THE SAME SIZE AND TYPE OF PAPER IN EACH TRAY
1 Load the same size and type of paper in each tray.
2 Move the paper guides to the correct positions for the paper size loaded in each tray.
M
AKE SURE THE
P
APER
S
IZE AND
P
APER
T
YPE SETTINGS ARE THE SAME FOR EACH TRAY
1 Print a menu settings page and compare the settings for each tray.
2 If necessary, adjust the settings from the Paper Size/Type menu.
Note: None of the paper sources, trays, or feeders automatically sense the paper size. You must set the size from
the Paper Size/Type menu on the printer control panel or from the Embedded Web Server.
Troubleshooting
139