Dell ? PowerEdge 6800 - Manual (Page 25)

l When prompted to verify the change to the asset tag number, type y and press .
To view the Asset Tag utility help screen, type asset /? and press .
Baseboard Management Controller Configuration
The Baseboard Managment Controller (BMC) enables configuring, monitoring, and recovery of systems remotely. BMC provides the following features:
l Uses the system's serial port and integrated NIC.
l Fault logging and SNMP alerting.
l Access to system event log and sensor status.
l Control of system functions including turning the power on and off.
l Support is independent of the system's power or operating state.
l Provides text console redirection for system setup, text-based utilities, and operating system consoles.
Entering the BMC Setup Module
1. Turn on or restart your system.
2. Press when prompted after POST.
If your operating system begins to load before you press , allow the system to finish booting, and then restart your system and try again.
For information on using and configuring BMC, see the documentation for the BMC and systems management applications.
Back to Contents Page
NOTE: To use the BMC feature, your network must be connected through the integrated NIC1 connector. See Figure 1 -4 .