beautypg.com

Pin definitions – Cypress CY7C1394BV18 User Manual

Page 7

background image

CY7C1392BV18, CY7C1992BV18
CY7C1393BV18, CY7C1394BV18

Document #: 38-05623 Rev. *D

Page 7 of 31

CQ

Echo Clock

CQ is Referenced with Respect to C. This is a free-running clock and is synchronized to the input clock
for output data (C) of the DDR-II. In the single clock mode, CQ is generated with respect to K. The timings
for the echo clocks is shown in the

Switching Characteristics

on page 23.

CQ

Echo Clock

CQ is Referenced with Respect to C. This is a free-running clock and is synchronized to the input clock
for output data (C) of the DDR-II. In the single clock mode, CQ is generated with respect to K. The timings
for the echo clocks is shown in the

Switching Characteristics

on page 23.

ZQ

Input

Output Impedance Matching Input. This input is used to tune the device outputs to the system data bus
impedance. CQ, CQ, and Q

[x:0]

output impedance are set to 0.2 x RQ, where RQ is a resistor connected

between ZQ and ground. Alternatively, this pin can be connected directly to V

DDQ

, which enables the

minimum impedance mode. This pin cannot be connected directly to GND or left unconnected.

DOFF

Input

DLL Turn Off

Active LOW. Connecting this pin to ground turns off the DLL inside the device. The timing

in the DLL turned off operation differs from those listed in this data sheet.

TDO

Output

TDO for JTAG.

TCK

Input

TCK Pin for JTAG.

TDI

Input

TDI Pin for JTAG.

TMS

Input

TMS Pin for JTAG.

NC

N/A

Not Connected to the Die. Can be tied to any voltage level.

NC/36M

N/A

Not Connected to the Die. Can be tied to any voltage level.

NC/72M

N/A

Not Connected to the Die. Can be tied to any voltage level.

NC/144M

N/A

Not Connected to the Die. Can be tied to any voltage level.

NC/288M

N/A

Not Connected to the Die. Can be tied to any voltage level.

V

REF

Input-

Reference

Reference Voltage Input. Static input used to set the reference level for HSTL inputs, Outputs, and AC
measurement points.

V

DD

Power Supply Power Supply Inputs to the Core of the Device.

V

SS

Ground

Ground for the Device.

V

DDQ

Power Supply Power Supply Inputs for the Outputs of the Device.

Pin Definitions

(continued)

Pin Name

IO

Pin Description

[+] Feedback

This manual is related to the following products: