Citizen Systems 291 - Manual (Page 46)

CBM-290/291 User’s Manual
32 CITIZEN
(22) Generating specified Pulse (ESC p m n1 n2)
Code : [1B]h + [70]h + m + n + n2
* {m = connector pin No. (See table below.)}
{0
≤
n1
≤
FF}
{0
≤
n2
≤
FF} Data is described in Hex code.
Signals specified by n1, n2 are output to Connector Pin m.
•
Bit m (m0) means the followings.
m0 Condition
0 Drawer kick No. 2 pin
1 Drawer kick No. 5 pin
•
ON time is considered as n1 x 2ms and OFF time as n2 x 2ms.
•
When m is out of the defined range, n1, n2 are discarded, where no signals are output.
•
Drive duty of Drawer is shown below:
(Take OFF time as being 4 times or more longer than ON time.)
(23) Selecting Character Code Table (ESC t n)
Code : [1B]h + [74]h + n
* {0
≤
n
≤
1} Data is described in Hex code.
Selecting Page n on the character code table:
•
"n" means the followings.
n (Hex) Condition
0 IBM Character #2
1 Japanese Character
•
The initial value of n is specified by Jumper setting (J1 - J3).
≤
0.2
ON time
ON time + OFF time